Deep vibrators Krasny'i Mayak IV-75, IV-113, IV-117A, etc.

Deep vibrators for concrete with a flexible shaft (IV-75, IV-113, IV-117A, etc.) consist of three main components - an electric drive, a flexible shaft, a vibrating tip.
Deep vibrators of the IV-117A and IV-116A-1,6 brands are connected via a step-down transformer to a network with a voltage of 380V, 3 phases, 50Hz. The EPK-1300 and EPK-1800 sets are designed to be powered from a single-phase mains voltage of 220V AC with a frequency of 50 Hz through an electrical shutdown device.

• Deep vibrators with a flexible shaft. Technical specifications.
• IV-117A, IV-116A-1,6, EPK-1800, EPK-1300, BP-5,5. Technical characteristics.
• Accessories for vibrators with a flexible shaft. Technical specifications.

---

Vibrators with a built-in electric motor (deep) IV-78, IV-102A, IV-103 consist of a vibrating tip, a switch box and a rubber sleeve connecting them with a cable located in it.

• Vibrators with built-in electric motor. Technical specifications.

---

The vibrators of the IVAI series consist of a vibrating tip and an inverter (a current and voltage frequency converter) made in an aluminum housing with a mains wire, with an electrical protective disconnection device (RCD) attached to it, designed for a nominal disconnecting differential current of no more than 30 mA.

• IWAI-38, IWAI-50, IWAI-60, IWAI-75. Technical specifications.

---

Vibrators of the IVAR series consist of a vibrating tip and a plastic box with a switch connected to each other by a rubber sleeve. A power cable equipped with a Euroville is connected to the box with the switch.

• IVAR-38, IVAR-50, IVAR-60, IVAR-75. Technical specifications.

---

Deep mounted vibrators for technological equipment IV-95A and IV-114A are designed for laying concrete and are used as a component on vibro-pavers equipped with a frequency converter (generator) with a current frequency of 200 Hz with a voltage of 127 (220) V, included in the set of machines for high-speed construction of highways, airfield runways and for the study of concrete mix in building structures.

• Vibrators are deep mounted. Technical specifications.

---

IV-115, IV-120, IV-121 are designed for compaction of concrete mixtures when laying them in monolithic structures with various degrees of reinforcement in hydraulic engineering, as well as in the manufacture of concrete and reinforced concrete products for prefabricated construction with a step between the reinforcement rods of at least 1.5 diameter of the vibrating tip (from 42 and 57 mm, respectively).

• IV-115, IV-120, IV-121. Technical specifications.

---

High-frequency deep vibrators of the AK series are equipped with a built-in converter and an electric motor of increased resource in the vibratory tip of the vibrator.

• Vibrators of the AK series . Technical specifications.

---

The EPA-220 battery electric drive, complete with a flexible shaft and a vibrating tip Ø 28 mm, is most effectively used in hard-to-reach places where it is difficult to use a tool with a conductive cable.

• EPA-220. Technical specifications.

---

SPARE PARTS ARE NOT ON SALE.